PLC-RSC-230UC/ 1AU/SEN

https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Please be informed that the data shown in this PDF Document is generated from our Online Catalog. Please find the complete data in the user's documentation. Our General Terms of Use for Downloads are valid (http://phoenixcontact.com/download) PLC-INTERFACE for input functions, consisting of PLC-BSC…/SEN basic terminal block with screw connection and plug-in miniature relay with multi-layer gold contact, for mounting on DIN rail NS 35/7,5, 1 N/O contact, input voltage 230 V AC/220 V DC Product Features  Efficient connection to system cabling using V8 adapter  Time savings of up to 60 %  No need for additional modular terminal blocks  Relay modules with safe isolation according to DIN EN 50178 between coil and contact  Space savings of up to 80 %  Sensor connected directly to relay module  Functional plug-in bridges     Key commercial data Packing unit 1 pc GTIN Weight per Piece (excluding packing) 35.44 GRM Custom tariff number 85364900 Country of origin Germany Technical data Note Utilization restriction EMC: class A product, see manufacturer's declaration in the download area Dimensions Width 6.2 mm 10/10/2014   Page 1 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Technical data Dimensions Height 80 mm Depth 94 mm Ambient conditions Ambient temperature (operation) -40 °C ... 60 °C Ambient temperature (storage/transport) -40 °C ... 85 °C Coil side Nominal input voltage UN 230 V AC (220 V DC) 220 V DC Typical input current at UN 3.2 mA Typical response time 7 ms Typical release time 15 ms Operating voltage display Yellow LED Protective circuit Bridge rectifier Bridge rectifier Contact side Contact type 1 N/O contact Contact material AgSnO, hard gold-plated Maximum switching voltage 30 V AC 36 V DC Minimum switching voltage 100 mV (at 10 mA) Maximum inrush current 50 mA Min. switching current 1 mA (at 24 V) Limiting continuous current 50 mA Interrupting rating (ohmic load) max. 1 W (at 24 V DC) Note the following values are applicable if a gold layer is destroyed Maximum switching voltage 250 V AC/DC Minimum switching voltage 5 V (at 100 mA) Limiting continuous current 6A Min. switching current 10 mA (at 12 V) Interrupting rating (ohmic load) max. 140 W (at 24 V DC) 20 W (at 48 V DC) 18 W (at 60 V DC) 23 W (at 110 V DC) 40 W (at 220 V DC) 1500 VA (for 250 V AC) Switching capacity in acc. with DIN VDE 0660/IEC 60947 2 A (at 24 V, DC13) 0.2 A (at 110 V, DC13) 10/10/2014   Page 2 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Technical data Contact side 0.1 A (at 220 V, DC13) 3 A (at 24 V, AC15) 3 A (at 120 V, AC15) 3 A (at 230 V, AC15) General Test voltage relay winding/relay contact 4 kV AC (50 Hz, 1 min.) Operating mode 100% operating factor Mechanical service life 2 x 10 cycles Inflammability class according to UL 94 V0 Designation Standards/regulations Standards/regulations IEC 60664 7 EN 50178 IEC 62103 Pollution degree 3 Surge voltage category III Mounting position any Assembly instructions In rows with zero spacing Connection data Connection method Screw connection Stripping length 8 mm Conductor cross section stranded min. 0.14 mm² Conductor cross section stranded max. 2.5 mm² Conductor cross section solid min. 0.14 mm² Conductor cross section solid max. 2.5 mm² Conductor cross section AWG/kcmil max 14 Conductor cross section AWG/kcmil min. 26 Screw thread M3 Classifications eCl@ss eCl@ss 4.0 27371102 eCl@ss 4.1 27371102 eCl@ss 5.0 27371001 eCl@ss 5.1 27371001 eCl@ss 6.0 27371001 10/10/2014   Page 3 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Classifications eCl@ss eCl@ss 7.0 27371001 eCl@ss 8.0 27371001 ETIM ETIM 2.0 EC000196 ETIM 3.0 EC000196 ETIM 4.0 EC000196 ETIM 5.0 EC000196 UNSPSC UNSPSC 6.01 30211916 UNSPSC 7.0901 39121515 UNSPSC 11 39121515 UNSPSC 12.01 39121515 UNSPSC 13.2 39121515 Approvals Approvals Approvals UL Recognized / UL Listed / cUL Recognized / GOST / cUL Listed / GL / cULus Recognized / cULus Listed Ex Approvals Approvals submitted Approval details UL Recognized  UL Listed  10/10/2014   Page 4 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Approvals cUL Recognized  GOST  cUL Listed  GL  cULus Recognized  cULus Listed  Accessories Accessories Bridge Continuous plug-in bridge - FBST 500-PLC RD - 2966786 Continuous plug-in bridge, Length: 500 mm, Color: red     10/10/2014   Page 5 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories Continuous plug-in bridge - FBST 500-PLC BU - 2966692 Continuous plug-in bridge, Length: 500 mm, Color: blue     Continuous plug-in bridge - FBST 500-PLC GY - 2966838 Continuous plug-in bridge, Length: 500 mm, Color: gray     Single plug-in bridge - FBST 6-PLC RD - 2966236 Single plug-in bridge, Length: 6 mm, Number of positions: 2, Color: red     Single plug-in bridge - FBST 6-PLC BU - 2966812 Single plug-in bridge, Length: 6 mm, Number of positions: 2, Color: blue     Single plug-in bridge - FBST 6-PLC GY - 2966825 Single plug-in bridge, Length: 6 mm, Number of positions: 2, Color: gray     10/10/2014   Page 6 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories Single plug-in bridge - FBST 8-PLC GY - 2967688 Single plug-in bridge, Length: 8 mm, Number of positions: 2, Color: gray     Controller board System connection - PLC-V8/FLK14/IN - 2296553 V8L-INPUT adapter for eight 6.2 mm PLC interfaces (1 PDT, etc./see "Supplementary Products"). 14-pos. flat-ribbon cable connection for the PLC system cabling, control logic: Plus switching     System connection - PLC-V8/FLK14/IN/M - 2304115 V8L-INPUT adapter for eight 6.2 mm PLC interfaces (1 PDT, etc./see "Supplementary Products"). 14-pos. flat-ribbon cable connection for the PLC system cabling, control logic: Minus switching     System connection - PLC-V8/D15S/IN - 2296074 V8-INPUT adapter for eight 6.2 mm PLC interfaces (1 PDT, etc./see "Additional Products"). 15-pin D-SUB male connector, control logic: Positive switching     System connection - PLC-V8/D15B/IN - 2296087 V8-INPUT adapter for eight 6.2 mm PLC interfaces (1 PDT, etc./see "Additional Products"). 15-pin D-SUB female connector, control logic: Positive switching     10/10/2014   Page 7 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories Labeled terminal marker Zack marker strip - ZB 6,LGS:FORTL.ZAHLEN - 1051016 Zack marker strip, Strip, white, labeled, can be labeled with: Plotter, Printed horizontally: Consecutive numbers 1 - 10, 11 - 20, etc. up to 491 - 500, Mounting type: Snap into tall marker groove, for terminal block width: 6.2 mm, Lettering field: 6.15 x 10.5 mm     Mounting rail DIN rail, unperforated - NS 35/ 7,5 V2A UNPERF 2000MM - 0801377 DIN rail, unperforated, Width: 35 mm, Height: 7.5 mm, Length: 2000 mm, Color: silver     DIN rail perforated - NS 35/ 7,5 PERF 2000MM - 0801733 DIN rail, material: steel galvanized and passivated with a thick layer, perforated, height 7.5 mm, width 35 mm, length: 2000 mm     DIN rail, unperforated - NS 35/ 7,5 CU UNPERF 2000MM - 0801762 DIN rail, material: Copper, unperforated, height 7.5 mm, width 35 mm, length: 2 m     DIN rail, unperforated - NS 35/15 UNPERF 2000MM - 1201714 DIN rail, material: Steel, unperforated, height 15 mm, width 35 mm, length: 2 m     10/10/2014   Page 8 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories DIN rail, unperforated - NS 35/15 CU UNPERF 2000MM - 1201895 DIN rail, material: Copper, unperforated, 1.5 mm thick, height 15 mm, width 35 mm, length: 2 m     DIN rail, unperforated - NS 35/15-2,3 UNPERF 2000MM - 1201798 DIN rail, material: Steel, unperforated, 2.3 mm thick, height 15 mm, width 35 mm, length: 2 m     DIN rail, unperforated - NS 35/15 AL UNPERF 2000MM - 1201756 DIN rail, deep drawn, high profile, unperforated, 1.5 mm thick, material: aluminum, height 15 mm, width 35 mm, length 2000 mm     DIN rail perforated - NS 35/15 PERF 2000MM - 1201730 DIN rail, material: steel galvanized and passivated with a thick layer, perforated, height 15 mm, width 35 mm, length: 2000 mm     DIN rail, unperforated - NS 35/ 7,5 UNPERF 2000MM - 0801681 DIN rail, material: Steel, unperforated, height 7.5 mm, width 35 mm, length: 2 m     Partition plate 10/10/2014   Page 9 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories Separating plate - PLC-ATP BK - 2966841 Separating plate, 2 mm thick, required at the start and end of a PLC terminal strip. Furthermore, it is used for: visual separation of groups, safe isolation of different voltages of neighboring PLC relays in acc. with DIN VDE 0106-101, isolation     Power module Power terminal block - PLC-ESK GY - 2966508 Power terminal block, for the input of up to four potentials, for mounting on NS 35/7.5     Screwdriver tools Screwdriver - SZF 1-0,6X3,5 - 1204517 Actuation tool, for ST terminal blocks, also suitable for use as a bladed screwdriver, size: 0.6 x 3.5 x 100 mm, 2component grip, with non-slip grip     Terminal marking Zack marker strip - ZB 6:UNBEDRUCKT - 1051003 Zack marker strip, Strip, white, unlabeled, can be labeled with: Plotter, Mounting type: Snap into tall marker groove, for terminal block width: 6.2 mm, Lettering field: 6.15 x 10.5 mm     10/10/2014   Page 10 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Accessories Zack marker strip - ZB 6/WH-100:UNBEDRUCKT - 5060935 Zack marker strip, Strip, white, unlabeled, can be labeled with: Plotter, Mounting type: Snap into tall marker groove, for terminal block width: 6.2 mm, Lettering field: 6.15 x 10.5 mm     Drawings Circuit diagram 13 A2 14 BB A1 10/10/2014   Page 11 / 12 https://www.phoenixcontact.com/us/products/2966333 Relay Module - PLC-RSC-230UC/ 1AU/SEN - 2966333 Diagram Curve A Maximum permissible continuous voltage Umax with limiting continuous current on the contact side (see relevant technical data) Curve B Minimum permissible operate voltage Uop after pre-excitation (see relevant technical data) Phoenix Contact 2014 © - all rights reserved http://www.phoenixcontact.com 10/10/2014   Page 12 / 12